PFT-1016 HS      

Self-igniting, clean-burning  powerful flame for medium to large jobs. Recommended for installation of all high and low voltage products. Comes with 9/16-L.H.male thread end fitting for easy adaptation to standard propane hoses. Approximately  32,000 BTU/hour.

Torch Only: Hose, regulator and tank not included.

PR-1010 

Regulator, fixed with tailpiece.

PR-1030            

Regulator, variable with guage  (0-30 psi)

PR-1035

Regulator, fixed pressure, with end fitting for disposable propane cylinder and  3 foot hose, fixed at regulator

PH-1110            

10 foot long LPG hose with  female threads each end

PH-1120

20 foot long LPG hose with  female threads each end

HAG-110           

110 volt Hot air gun for use on all low voltage products and most medium voltage accessories.  Not recommended for MV. Splices

HAG-220           

220 volt Hot air gun for use on all low voltage products and most medium voltage accessories.  Not recommended for MV. Splices

SH-1412            

Heat shield: woven fabric with eyelets.  Protects adjacent components from torch heat for safety:  Size  12" X 40"

MSH 2015 

Tinned copper mesh width 2.50"; 15 foot roll

MSH 2030          

Tinned copper mesh width 2.50"; 30 foot roll

MSH 2050          

Tinned copper mesh width 2.50"; 50 foot roll

Gmod 

Solderless ground clamp accessory contains: stainless steel, constant force spring, conductive adhesive-backed copper foil tape, moisture blocked, tinned copper braid and installation guide.

Gmod 1      For a cable insulation diameter range of  0.30" - 1.25" with a #10 AWG solder-blocked, tinned copper 24" braid

Gmod 2      For a cable insulation diameter range of  0.95" - 2.15" with a #7 AWG solder-blocked, tinned copper 24" braid

Gmod 3      For a cable insulation diameter range of  1.55" - 3.40" with a #4 AWG solder-blocked, tinned copper 24" braid

Pmod                

Pmod kit preparation kit contains: 6 solvent-saturated, lint-free cloths with one #120 grit aluminum oxide abrasive strip, 24" long. One Pmod kit is required for three 1/C or one, 3/C terminations or joints.

Pmod2          

P mod2 kit preparation kit contains: 2 solvent-saturated, lint-free cloths with                 one #120 grit aluminum oxide abrasive strip, 12" long. One Pmod2 kit is required for one each 1/C terminations or a 1/C joints.

Emod                

E mod kits are heatshrinkable nontracking weather sheds for increasing the surface creepage distance of the IPP type MVT indoor termination(s). 

Shed requirements:  5 & 8 kV=1   •   15 kV=2   •  25 kV=3   •   35 kV=4.

Standard package is 3 sheds per package.

Emod1     For a cable insulation diameter range of  0.35" - 0.85"

Emod2     For a cable insulation diameter range of  0.80" - 1.50"

Emod3     For a cable insulation diameter range of  1.10" - 2.00"